614.766.2858

Radon Mitigation

The Mitigation Process

Residential.

Commercial.

New & Existing.

The Radon Mitigation Process

Mitigation and remediation mean the same thing.

TEST

We’ll test your building’s air for excessive radon

INSTALL

We’ll install your new radon mitigation solution

TEST AGAIN

Within 30 days, we’ll return to retest your air

CERTIFY

You are protected and can breathe a little easier

Mitigation vs. Remediation

Radon mitigation and radon remediation mean the same thing.  They both describe the process of effectively reducing indoor airborne radon levels to below the EPA guidelines of 4 picocuries per liter (pCi/L).

We accomplish this by locating the points of entry, sealing them, and using a quiet exhaust fan(s) to push the gas outside. Points of entry are typically the area of lowest contact such as a basement, crawlspace, concrete slab, or parking garage.

The system can be installed one of two ways; either a concealed system, which runs the vent pipe through the garage or attic, or an exterior stack system which usually runs along the rear exterior of the house or building. (pictured below). We will discuss your radon mitigation plan with you in detail, and design it to be as unobtrusive as possible of course.

4.75

average client rating

Radon Mitigation Methods

Sub-Slab Depressurization (commonly called Sub-Slab Suction) is a mitigation method that extracts radon laden air from beneath the foundation of your building, then vents the radon gas to the outside using a commercial fan and duct(s). It is similar in appearance to a sump pump installation.

Sub-Membrane Ventilation is very similar to sub-slab suction, and is the most effective mitigation method for dirt floored basements and crawlspaces. A plastic collection barrier covers the soil and is connected to the mitigation fan which exhausts the radon-laden air to the outside of the building.

Block Wall Suction uses a fan and duct(s) to create a vacuum in the hollow cavities of a concrete block wall. This creates a negative pressure within the walls preventing radon escape into the basement. The mitigation fan system collects the radon-laden air and exhausts it to the outside of the structure.

What is radon mitigation?

Radon mitigation and radon remediation mean the same thing.  They both describe the process of effectively reducing indoor airborne radon levels to below the EPA guidelines of 4 picocuries per liter (pCi/L).

We accomplish this by locating the points of entry, sealing them, and using a quiet exhaust fan(s) to push the gas outside. Points of entry are typically the area of lowest contact such as a basement, crawlspace, concrete slab, or parking garage.

The system can be installed one of two ways; either a concealed system, which runs the vent pipe through the garage or attic, or an exterior stack system which usually runs along the rear exterior of the house or building. (pictured below). We will discuss your radon mitigation plan with you in detail, and design it to be as unobtrusive as possible of course.

Radon mitigation methods

Sub-Slab Depressurization (commonly called Sub-Slab Suction) is a mitigation method that extracts radon laden air from beneath the foundation of your building, then vents the radon gas to the outside using a commercial fan and duct(s). It is similar in appearance to a sump pump installation.

Sub-Membrane Ventilation is very similar to sub-slab suction, and is the most effective mitigation method for dirt floored basements and crawlspaces. A plastic collection barrier covers the soil and is connected to the mitigation fan which exhausts the radon-laden air to the outside of the building.

Block Wall Suction uses a fan and duct(s) to create a vacuum in the hollow cavities of a concrete block wall. This creates a negative pressure within the walls preventing radon escape into the basement. The mitigation fan system collects the radon-laden air and exhausts it to the outside of the structure.

4.75

average client rating

Why Choose Us for Radon Remediation

We have been doing this since 1988. Thousands of installations & repairs have made us experts at remediation.
Generally, the system installation doesn’t take long at all. It is backed with a fully transferable 5 year warranty.
We’re local. We are owned and operated by Columbus native Kevin Mullins. You will get care that you can’t find with a franchise.

©Aadvanced Aair - Radon  |  8164 Columbus Pike, Lewis Center, OH 43035  |  Marketing